ок, Махнали са 5 сигнала и са сложили 5 други...
Тогава преходника няма да е толкоз прост, но не го прави чак невъзможно, след като има инфо че 816 ( горе съм цитирал) е произвеждан и в съвместим с 6502 по цокъл формат...
pin-compatible variant of the W65C816S referred to as the W65C802.
Ще се разровя в 6502 форума и ще ги питам някой правил ли е такъв преходник и дали е възможно ест...
Я тука някой е направил прехоодник
http://forum.6502.org/viewtopic.php?t=186&postdays=0&postorder=asc&start=0и схемка
http://sbc.rictor.org/support/conv.htmlОще един адаптер,но за Commodore VIC-20,
http://www.baltissen.org/newhtm/02to816.htmСАмо Cync сигнала му липсва но от горната схема се вижда как може да се изработи.
Тестван и на Епъл 1 реплика
http://jefftranter.blogspot.co.uk/2012/06/replica-1-now-running-with-65816-cpu.htmlThe differences
The main differences between both processors are:
Pin 65816 6502
--- ------- --------
1 VP GROUND
3 ABORT CLK1
5 ML NC
7 VPA SYNC
35 E NC
36 BE NC
38 M/X SO
39 VDA CLK2
The 65816 lacks the CLK1 and CLK2 clock signals so we have to provide them ourselves. That's where two 74F04 inverters come in view.
ABORT and BE are 816-specific inputs and only need a pull-up resistor. These resistors enable you to use these inputs later. If you are sure you don't need them, just omit the resistors and connect these inputs directly to +5V (pin when the resistors are mentioned during the construction.
The 65816 has no SYNC or equivalent but we have to supply this output with a level and IMHO the safest level is (L). AFAIK the only system using SYNC is the KIM-1 and the Elector Junior.
The 65816 also lacks the SO-input. The only system I know using the SO-input is one of the Commodore drives: the 1541.
Схемка доста по проста: